Recent content by Cop Car

Very Nice Work....I made mine using a Front Apron...It is not correct but it is better than nothing....

If I'm not Mistaken...Any Reputable Speedometer Shop can Reprogram and Re Face the Speedometer to read to any Speed you want...But....It won't be cheap.....any one know of one???

I am looking for a set of Frame mounts and a set of Engine Plates for a 429 in a 71/73....The Isolaters are available everywhere, But I would be interested in a Full Setup.... I have the Crites Solid mounts for my Ranchero, but I want Rubbers for the Mach...

Pass side with AC....I have mine but it is Rusted through in Several places around the Bottom...I can Rebuild it but was trying to avoid the Time if I could find a Good one at a Resonable price (I know they are rare)..

Does anyone have or know where to get the Fresh Air Cowl "Hat" for the Fresh air vent ???? I looked at the Current "Repair" item that is Plastic...Not interested....

I Totally Agree....I don't care what I spend to build this car, or what someone else "Thinks" it's worth...I will be buried in it...I will never sell it because it is what I want to Drive.....:D

Thank You Very Very Much...This is Exactly what I needed....Thank You.... Mustangs Unlimited just got them Restocked...Got mine Yesterday after a Two month Wait.....

I am installing the Fold Down "Sport Deck" Rear seat and I need the Locating measurements for the Floor brackets... I have the new brackets and can figure "Kinda" where they go, but if anyone has an original with the seat out and could get me the measurements to locate it I would be very...

The Battery Box Support is not available....But I think I have a solution....I bought an Extra Apron and will cut out the shape of the support and Roll the edges to look "Kinda" factory....but that piece is needed to properly space the apron to the frame rail....

That is what I thought...Just a way to tell the Line workers what to install or not...Like the Honeycomb in the Tail light panel...

You don't have a POA valve...You have an Expansion Valve...If you convert to 134 (a Bad Idea, IMHO) just Replace the Expansion Valve with a 134 Compatiable one....A Better Idea would be to Charge the System with Freeze12....

Well Thanks...I know that.....I was wondering if there were SPECIFIC differences, and what they were.....

I had a Rust/Rot problem...Plus the Other crossmember was used to remove a Stump at some point in time...I was able to find a good used one from a Torino (or Cougar) and Replace it....The Other Crossmember I had to Take Apart and Straighten and weld back togather....

Does anyone know the Actual Difference between an 05 and an 02 Body????

Hello all, My name is Kelley and I live in Texas between Houston and San Antonio. I am in the Middle of a Restoration of a 72 Mach 1. I have several Ford Muscle Cars awaiting Restoration and look forward to contributing to this Forum...:shy: