Removing Grande logo

[Vinnie]

Hey folks,

I searched the forum but was unsuccesful in finding anything about this though I cannot imagine nobody posted about this before...

How can de "Grande" logo above the quarter panel be removed in a way that it can be replaced? From the inside I can't even locate it (I have all the inside panels and trim removed). From the shop manuals it looks like the logo has only 1 pin at the back that is pushed into a holder, not even screwed.

Any helpful tips would be appreciated!

Thanks,

Vincent.

 

[Bill73Ragtop]

If it's secured with barrel fasteners, dental floss is worth a try.

 

[Vinnie]

I guess you meant to put the dental floss behind it and then pull?

When I posted before I didn't know there was another hole that gives access to the pin in the fastener, that hole was covered by insulation.... duh! From the inside I gently tapped it out using an extention and hammer.

Also I thought the logo was made of plastic but it's metal so it won't break as easily.