Trans coolant lines

[jeremycfr]

We started to run the trans coolant lines today and their rubbing the headers. Any suggestions on a workaround? We're thinking of bending them to go under the starter.

 

[caspianwendell]

You can run under starter, or along the frame with custom made ones...I would keep them as far away from the headers as possible for cooling reasons

 

[JimNiki]

I routed the rubber lines through the front cross member from memory.

 

[OMS]

Jeremy, you need to bend them out/ away from the headers.

You don't need a ton of clearance, make sure they can't vibrate and rub them.

You can always get some hose [ fuel or heater ] cut it and clamp it on in that area for extra protection

Jim, original lines were steel - no rubber

 

[JimNiki]

Roger that.

The good old PO's at it again.