US Indy Mags

[PeteG41]

I replaced the lug nuts on mine, and still have the old nuts and the locks.
Just checked, and these have 11/16 shanks. You can have 'em if they'll help.
These are the ones I replaced.
View attachment 63826

Somehow didnt notice you mentioned you had some older ones you took off. Once I get mine measured ill shoot you a message to see if they will work!

 

[PeteG41]

Got a lug off…not quite sure why there are 2 washers though? I was under the impression there was only supposed to be one. Went to orielly, and I’m sure this is a very stupid question so bear with me, but will these work? Almost exactly the same length, my old one just has that slight taper

 

[1973 Mach-1]

They probably used the two washers to make up for the fact that the shank was a bit too long. You may still need the second washer.

 

[PeteG41]

Posted this thread a while back but looking for a little more info. One of the old lug nuts I had was pretty well seized on the rear studs. Took a few minutes with an impact to get it off. Long story short, I am going to replace the stud, maybe all 5 since I am right there. I did a ton of digging through old topics on this and found the stock size I am needing to get should be a .625 knurl? Just making sure I have that correct before I get 1/2 way done with this and I am wrong. Definitely don't like the $4 each price tag but what can you do. Looking at Dorman part # 610-109

 

[Hemikiller]

The rear studs are Ford pt# A9AZ-1107-B. Dorman 610-109 is the correct cross, but you can do way better than $4 each....

https://www.rockauto.com/en/moreinfo.php?pk=1060108&cc=1132995&pt=7680&jsn=893

 

[Sheriff41]

Try Rock Auto - they're $1.50/ea. or Amazon - $19.98 for 10.

 

[PeteG41]

The rear studs are Ford pt# A9AZ-1107-B. Dorman 610-109 is the correct cross, but you can do way better than $4 each....

https://www.rockauto.com/en/moreinfo.php?pk=1060108&cc=1132995&pt=7680&jsn=893

Holy price difference. Thats what I get for not checking rock auto first. Seeing as I don't need them asap definitely the way to go. Thank you as always. Grabbed a lug installer too while I was at it.