- Joined
- Sep 8, 2018
- Messages
- 2,042
- Reaction score
- 1,139
- Location
- Ross, Ohio
- My Car
- 71 Sportsroof Bright Red.
Needing a little help. Getting ready to pick the car up from the painter but before I do I am going to put the doors weather strips on. While there we notice that the seal channel on the bottom of the door is hitting the rocker (scuff plate area) in one spot. All the lines on the body look great. Is it ok to bend the channel some or should we try to adjust the door a little more. Afraid if we raise the door will have to do the fender also and start the old back and forth routine.
Also did a search on putting the seal on and seen one where the question came up about where to apply adhesive on the door where the seal sits in a right angle by the latch. Do you apply on both sides of the 90 or just one. If just one - outer side towards outside of door or the other.
Thanks for the help.
Also did a search on putting the seal on and seen one where the question came up about where to apply adhesive on the door where the seal sits in a right angle by the latch. Do you apply on both sides of the 90 or just one. If just one - outer side towards outside of door or the other.
Thanks for the help.