- Joined
- Jan 17, 2015
- Messages
- 1,776
- Reaction score
- 614
- Location
- California
- My Car
- 71' Grande project.
No, used it straight out of the can. Poured it in a small plastic bowl first and then dipped them. I just dipped just the top part in to cover the flat surface and then removed and let the excess drip off for a few seconds. I then turned it over 180 degrees and let it set before dipping again. I look for replacements at all the online sites when I was doing mine and couldn't find any. If you do find some please post where at. Here is aside view so you can see where it stops at. Hope this helps.Did you thin down the plastidip? I messed around with a spare set I had and the results were not as good.
I could swear I saw them being reproduced somewhere.
Enter your email address to join: