- Joined
- Jul 12, 2010
- Messages
- 5,427
- Reaction score
- 3,693
- Location
- Killingworth, CT
- My Car
- 71 Mach 1
71 XR-7 hardtop
71 Country Squire
65 hardtop
Listing this for a good friend who's decided a late 60's Fairlane is more to his liking.
1968 Coupe, C-code 289-2V, C4 auto. PS, manual drums, turn signal hood and floor console. Car is originally from California and is very clean all around other than the floors, passenger door and battery apron. Car was brought to CT in the mid 80's and was garaged up until the last couple years. Windshield gasket leaks, so it'll need floor pans or patches. Battery apron has normal rust. Quarters, torque boxes, floor supports, frame rails, trunk floor and all the other usual rot spots are in great shape. Passenger door needs replacement or serious surgery. Only filler I see in the car is the passenger lower fender and the pass door. Hood needs a little work, but is saveable. I also see no evidence of accident damage or prior panel replacement. Trim overall is in very good shape, quarter and vent window frame chrome is nice with minimal pitting and weathering.
Factory VIN stamped engine is in place, and appears to be mostly original. I haven't verified all the components for correct numbers, but it's all there and hasn't been *******ized. Engine starts with a little bit of smoke indicating it'll need valve seals. Sounds good and will only get better the more it's run, it's a little cold blooded like any car that's been sitting. Has good oil pressure and holds steady temp with good coolant flow. Trans drops into gear immediately, fluid is clean and smells good. New fuel tank, sender, and filler hose were installed this summer. Has a Pertronix Ignitor conversion in place of the factory points. Car starts, runs, stops and will do lot drives. It's not registered and it hasn't been on the road recently. Brakes were done with new lines, hoses and cylinders about ten years ago. Car comes with most trim parts that were taken off, as well as a bunch of spares. See pics in the album below. Not shown is the console, the two original black buckets in bad shape, and another blue bucket seat. Styled Steel wheels are Ford originals, not reproductions.
The car obviously will need a complete restoration, but is an easy project for those of us used to rust belt cars. With some basic maintenance items and a set of tires, I'm confident you could be making it to your local cruise or cars n coffee in no time.
Dropping price to $7,000 asking, car is located in Killingworth, CT 06419
SOLD SOLD SOLD to a great guy in NY
Link to Google photo album with detailed photos: https://photos.app.goo.gl/TfBLXgXgYBsf14KF8
8R01C104822
Super early San Jose built car.
65A - standard bucket seat interior
I - Lime Gold paint
2A - black all vinyl interior
12J - Sept 12 scheduled assembly date
72 - San Jose DSO
2 - 2.79 rear axle
W- C4 automatic
:
1968 Coupe, C-code 289-2V, C4 auto. PS, manual drums, turn signal hood and floor console. Car is originally from California and is very clean all around other than the floors, passenger door and battery apron. Car was brought to CT in the mid 80's and was garaged up until the last couple years. Windshield gasket leaks, so it'll need floor pans or patches. Battery apron has normal rust. Quarters, torque boxes, floor supports, frame rails, trunk floor and all the other usual rot spots are in great shape. Passenger door needs replacement or serious surgery. Only filler I see in the car is the passenger lower fender and the pass door. Hood needs a little work, but is saveable. I also see no evidence of accident damage or prior panel replacement. Trim overall is in very good shape, quarter and vent window frame chrome is nice with minimal pitting and weathering.
Factory VIN stamped engine is in place, and appears to be mostly original. I haven't verified all the components for correct numbers, but it's all there and hasn't been *******ized. Engine starts with a little bit of smoke indicating it'll need valve seals. Sounds good and will only get better the more it's run, it's a little cold blooded like any car that's been sitting. Has good oil pressure and holds steady temp with good coolant flow. Trans drops into gear immediately, fluid is clean and smells good. New fuel tank, sender, and filler hose were installed this summer. Has a Pertronix Ignitor conversion in place of the factory points. Car starts, runs, stops and will do lot drives. It's not registered and it hasn't been on the road recently. Brakes were done with new lines, hoses and cylinders about ten years ago. Car comes with most trim parts that were taken off, as well as a bunch of spares. See pics in the album below. Not shown is the console, the two original black buckets in bad shape, and another blue bucket seat. Styled Steel wheels are Ford originals, not reproductions.
The car obviously will need a complete restoration, but is an easy project for those of us used to rust belt cars. With some basic maintenance items and a set of tires, I'm confident you could be making it to your local cruise or cars n coffee in no time.
Dropping price to $7,000 asking, car is located in Killingworth, CT 06419
SOLD SOLD SOLD to a great guy in NY
Link to Google photo album with detailed photos: https://photos.app.goo.gl/TfBLXgXgYBsf14KF8
8R01C104822
Super early San Jose built car.
65A - standard bucket seat interior
I - Lime Gold paint
2A - black all vinyl interior
12J - Sept 12 scheduled assembly date
72 - San Jose DSO
2 - 2.79 rear axle
W- C4 automatic
:
Last edited:
