like finding a needle in a haystack..Mmmmm.... XE block = hen's tooth.
Sweet ::thumb::
That is a 65 thru 70 floor...not factory correct, but it does look better than rust or a patchjob. The only "problem" is half of the front ribs (under your feet) are on top of the front floor supports. In my case I removed the floor supports as I will be using 1-5/8x .083 round moly for a "frame" under the floor.Where did u get the full floor? Dynacorn? My floor is rusty so I might go full like you did. Looks good!
yes they do, just came out maybe month or so ago.They make the engine cross member now..?!?! Sweet! Nice job on the car. Taking notes for mine.
yes, we will have very good power. I will bring it out in C/S to start with. I have an approval for the 25.5B frame/cage for future HP upgrades, but I am still working on a manifold, they shot down the BT because of the notch in the plenum.Very nice Bill. Will this be a competitive stocker? I've been working as a crew member on a friends 72 E/S 351c H.O. Mustang for a few years now.
Enter your email address to join: