- Joined
- Feb 28, 2011
- Messages
- 2,194
- Reaction score
- 411
- Location
- Chattanooga, TN
- My Car
- 72 Mach 1 H-Code (Concourse)
67 GT S-Code 4sp
With the help of BKD I was able to get some old leaf springs he was not useing and remove the small leaf for the part number as well as the leaf clamps which were the correct OE pieces. I was able to reuse enough of the clamps to get one spring done, but need three more to finish the other spring. If you have some old leaf springs sitting around that have lost the arch in them could I possibly get the clamps off them. I have attached a picture of what I am looking for. The OE clamps have a round hole vs a square hole. The problem is that the little tab that bends over tends to wear thin from the elements over time and often break off. If you have some clamps and would not mind taking the time to remove the clamps I will pay for mailing them. The replacement clamps have a square hole. One clamp is bigger to go around the entire leaf pack and the other two are smaller just to go around two leafs.
Last edited by a moderator: