Ratcheting Shift Lever

[timsweet]

I now understand why people don't replace the parts, but only attach an after-market fix.  This is a PITA.  Especially with the trans still in place.

What is the best way to remove the nut holding lever on?

https://preview.ibb.co/d5MwH9/IMG_20180908_142326086.jpg[/img]

I'm seriously considering just replacing the ratcheting shift component.

Thanks

tim

 

[Don C]

I modified an end wrench so it could get into it.

 

[timsweet]

I modified an end wrench so it could get into it.

I have a set of open wrenches for a ratchet, but the don't fit in to the space.  The nut is 3/4 or larger.

 

[timsweet]

I modified an end wrench so it could get into it.

I have a set of open wrenches for a ratchet, but the don't fit in to the space.  The nut is 3/4 or larger.

 I may try a pair of needle nose vice grips and then try turning the outer end with vice grips.

 

[Don C]

Here are the pictures of my modified wrench. The end for the nut on the shift lever is on the right. I started with a 3/4" wrench, but had to widen it out to fit the nut. It measures slightly less than 7/8".