amach1
New member
- Joined
- Feb 7, 2020
- Messages
- 1
- Reaction score
- 0
- Location
- Pennsylvania
- My Car
- 1971 Mach 1 Fast Back - Perfect for a project
Hi everyone,
1971 Mustang Mach 1 Project Car. Originally grabber Yellow
Photos are the most recent that I have of the car. Not looking to part out at this time.
Car is located in Chester Springs, PA.
Purchased 12 years ago from a body shop that did the quarter panels and other body work to the car. Car has been sitting untouched for a while and it's time to let it go to someone who will finish it.
Most all parts are there. Fender aprons, rad support, and trunk pan were replaced. Frame rust near drivers shock tower was repaired. Aprons near cowl could be replaced or repaired.
Summary:
- 351C, 2V, On stand, In middle of rebuild. 1972 block bored .030" over. Block was checked for cracks and tolerances by machine shop. no carb or manifold.
- 9" rear with limited slip
- 31 spline Yukon alloy axles
- FMX automatic transmission (also have a C4 that can go with it with driveshaft)
- Tachometer in dash
- Fenders are straight and solid
- Urethane front bumper
- Good Mach 1 grille (71 &72 horizontal lights)
- Hood with scoop holes (has holes from hood pins)
- Front disc brake spindles
- new control arms
- new springs
- new steering joints
- all glass is good
- new carpet in box
- Trim, seats (possible reupholster), and all other items are included.
Asking $4500
Serious inquires only - Please contact Amanda @ 484.six5three.77fivetwo
1971 Mustang Mach 1 Project Car. Originally grabber Yellow
Photos are the most recent that I have of the car. Not looking to part out at this time.
Car is located in Chester Springs, PA.
Purchased 12 years ago from a body shop that did the quarter panels and other body work to the car. Car has been sitting untouched for a while and it's time to let it go to someone who will finish it.
Most all parts are there. Fender aprons, rad support, and trunk pan were replaced. Frame rust near drivers shock tower was repaired. Aprons near cowl could be replaced or repaired.
Summary:
- 351C, 2V, On stand, In middle of rebuild. 1972 block bored .030" over. Block was checked for cracks and tolerances by machine shop. no carb or manifold.
- 9" rear with limited slip
- 31 spline Yukon alloy axles
- FMX automatic transmission (also have a C4 that can go with it with driveshaft)
- Tachometer in dash
- Fenders are straight and solid
- Urethane front bumper
- Good Mach 1 grille (71 &72 horizontal lights)
- Hood with scoop holes (has holes from hood pins)
- Front disc brake spindles
- new control arms
- new springs
- new steering joints
- all glass is good
- new carpet in box
- Trim, seats (possible reupholster), and all other items are included.
Asking $4500
Serious inquires only - Please contact Amanda @ 484.six5three.77fivetwo