Found a source for the kick-down-rod for the 429 CJ/SCJ, but it won't be available until after 4/15. Does anyone have a spare kick-down-rod and wants to move it? Contact me. Thanks.
Till you have the piece avail, why not bend a piece of aluminium tube using home water piping tools. Press it at ends with a washer/rivet, drill and bam, you have one ready in max 30 mins of work till you can get the exact same one by mid April
I made mine up from aluminium tubing as Fabrice suggested above. A couple of nylon insulator washers were pressed into to the holes for wear resistance.
I made mine up from aluminium tubing as Fabrice suggested above. A couple of nylon insulator washers were pressed into to the holes for wear resistance.
@ponypastor I have my original 429CJ one. I'll try make picts for you this weekend may you do not get others by then.
Don't hesitate bug me if I forget!
Fabrice's offer is probably your best bet if it's out of the car. Mine is installed so a bit of an issue to get accurate dimensions you require. Also mine was slightly modded to match up with the Brawler carby. I didn't have an original to copy. Tubing is 12mm OD from the local hardware store.
Found a source for the kick-down-rod for the 429 CJ/SCJ, but it won't be available until after 4/15. Does anyone have a spare kick-down-rod and wants to move it? Contact me. Thanks.
Thanks for your post. Can you provide the dimensions of the rod: length of entire rod and distance between the various curves. And, are you willing to sell it? Thank you.
Pics are of a 351CJ w/C6 kickdown linkage and are from the left side of the kickdown linkage except where noted looking from the rear of the linkage. Overall length is ~33 inches. I tried to capture measurements and label pics clearly. If you need additional measurements or angles just let me know.
Attachments
351 CJ C6 Kickdown.jpg
187 KB
· Views: 1
351 CJ C6 Kickdown view towards the front of car.jpg
151.5 KB
· Views: 1
351 CJ C6 Kickdown offset measurement.jpg
150.6 KB
· Views: 0
351 CJ C6 Kickdown Carb End.jpg
382.9 KB
· Views: 0
351 CJ C6 Kickdown Carb End 1st bend.jpg
245.8 KB
· Views: 0
351 CJ C6 Kickdown Carb End 2nd bend.jpg
294.9 KB
· Views: 0
351 CJ C6 Kickdown Carb End to end of 2nd bend.jpg
193.2 KB
· Views: 1
351 CJ C6 Kickdown length of 2nd bend.jpg
294.9 KB
· Views: 1
351 CJ C6 Kickdown Carb End 2nd bend to 3rd & 4th bend.jpg
184.3 KB
· Views: 1
351 CJ C6 Kickdown 3rd bend to 4th bend.jpg
78.4 KB
· Views: 1
351 CJ C6 Kickdown 4th bend to transmission end from above.jpg
254.7 KB
· Views: 1
351 CJ C6 Kickdown 4th bend to transmission end.jpg