Hey guys, i got the 408 in and running but not getting a charge at the battery. I was wondering if someone could tell me if the S terminal at the regulator is suppose to have a swithced 12volts hooked to it?? My alternator only has 2 wires going to it. 35 and 36 on the wiring diagram from the regulator. Only 3 wires are used on the regulator. F S A. F35, S904, A36. It looks like 904 is going to the run position on the ignition switch. Does this sound right?? I had my alt tested and it is working fine, and i replaced the voltage regulator, but i am suspecting that i dont have 12volts at S/904. Would this cause the battery not to charge?? If so all i have to do is get a switched 12 volt source for the regulator and it should work?? Any help is appriciated! I am going to inspect all the wires again and check all my grounds again just to be sure but i think my problem is the no voltage to the regulator.