mikleins29
Well-known member
- Joined
- Dec 10, 2011
- Messages
- 131
- Reaction score
- 0
- Location
- omaha
- My Car
- 71 fastback 351cleveland 4 speed
Is it possible to replace crankshaft and bearings on the engine stand with heads on?
I don't see why not. If it's upside down, the spark plugs out and the pistons slid up in the cylinders, it should work. You will need help to make sure the crank doesn't contact the connecting rods unless they are lined up properly. That may take a couple extra sets of hands. Once in place, tighten your mains and check clearances. Don't forget to check rod bearing clearances, too.Is it possible to replace crankshaft and bearings on the engine stand with heads on?
Enter your email address to join: