Possible to Modify RH Exterior Door Handle to LH?

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

4mm

Well-known member
Joined
Aug 26, 2012
Messages
447
Reaction score
3
Location
S. TX
My Car
1971 Mustang 351C 4V Fastback
Hello All,

I can seem to easily find inexpensive RH NOS exterior door handles but no left-hand (driver side) door handles.

I have found a couple of left-hand door handles but they are very expensive. I seem to recall a thread where somebody said it was possible to swap the inner mechanism since the outer part of the handles are exactly the same.

Does anybody have any info that can help me? TIA.

 
Last edited by a moderator:
Maybe that is possible, I believe that grasping piece is different side to side. I believe that they have different casting numbers, so that leads me to think that fixed portion is different also.

 
Thanks for the info.

Anybody else have anything to add I'd appreciate it.

 
These handles were left and right. The part of the handle that faced the rear of the car had the provision to hold the rod that went down to the latch that released when the handle was pulled up. I've seen prices for a NOS unit's run from $40-$50, right up to $200.00. This style handle was used on 71-72 Full size Ford's, 72-76 T-Bird's, 82-89 Lincoln's (Mostly Town Cars), sister Mercury car's, and of course 71-3 Mustangs. I would check with Don (OMS) to see if he might have some NOS handles or maybe a repo that he recommended.

If you do search E-Bay look for E25Y-5422405-A, which replaced D1AZ-6522405-A.

Get your credit card out and Good Luck on your search!

 
Last edited by a moderator:
Back
Top