Parkka
Well-known member
- Joined
- Jan 12, 2019
- Messages
- 129
- Reaction score
- 13
- Location
- New England
- My Car
- 73 Mustang Convertible
[url=https://ibb.co/cgCFb3N][img]https://i.ibb.co/j6WMVfL/IMG-20190713-145003409.jpg[/img][/url]
Shown below is my 28 spline rear axle from an 8 inch casing.
One of the parts required for the rebuild is the rear wheel bearing retainer (NPD # 4020-1).
This retainer with the small hollow at the bottom is also shown in the parts manual for Ford with what appears to be a gasket (parts 4234 & 1001).
However, my axle set up does not have this. It appears the retainer is flat on all sides without the hollow and there is no gasket.
Do i need to replace the retainer i have with the one shown in the parts manual and advertised in NPD?
Am i missing something here?
Thanks
Dan
https://ibb.co/KNHQg5w
[/URL]
One of the parts required for the rebuild is the rear wheel bearing retainer (NPD # 4020-1).
This retainer with the small hollow at the bottom is also shown in the parts manual for Ford with what appears to be a gasket (parts 4234 & 1001).
However, my axle set up does not have this. It appears the retainer is flat on all sides without the hollow and there is no gasket.
Do i need to replace the retainer i have with the one shown in the parts manual and advertised in NPD?
Am i missing something here?
Thanks
Dan
https://ibb.co/KNHQg5w