Denise1972
Member
- Joined
- Oct 6, 2019
- Messages
- 7
- Reaction score
- 1
- Location
- Bryan Ohio
- My Car
- 1972 Mustang Mach 1 351c with aod trans and 3.89 rear end
Hi Everyone.
I was wondering if anyone has the shim template tool T68P-4946A ? It is used to set the clutch pak on a trac loc 9 in.
What I need is the length of the tool plus the height of the two legs that set on the clutch hub, and height of the leg that you put the feeler gauge under to check the clearance. I can make the tool if I have that info. I have been to every ford dealer in our area and not a one had that tool.
Thank you
Jack
I was wondering if anyone has the shim template tool T68P-4946A ? It is used to set the clutch pak on a trac loc 9 in.
What I need is the length of the tool plus the height of the two legs that set on the clutch hub, and height of the leg that you put the feeler gauge under to check the clearance. I can make the tool if I have that info. I have been to every ford dealer in our area and not a one had that tool.
Thank you
Jack