JimBrown55
Member
My 351c 2V has A/C, and the gigantic compressor and brackets to go with it. I tested the stock vacuum advance can, (with a slightly curved actuator shaft extending into the diz) and found it wasn't moving with vacuum (either manifold, carb, or my face), so I decided to replace it.
My FLAPS had one (eventually) with the correct actuator shaft, but the thing is large, really large, and it won't allow me to time the engine correctly, and with a small enough turning radius because it hits the A/C brackets.
So, I don't have a service manual for this car yet, and I also don't know where the old one is anymore to find a part number for the one that will actually turn in the space allowed.
Anyone have the Ford part number handy for the original, and maybe who carries it, even if it's only available from a Ford dealer? My FLAPS do not, yet. I already replaced the points with Pertronix, and do not want to buy an MSD etc., so.......any help?
Thanks in "advance"!
My FLAPS had one (eventually) with the correct actuator shaft, but the thing is large, really large, and it won't allow me to time the engine correctly, and with a small enough turning radius because it hits the A/C brackets.
So, I don't have a service manual for this car yet, and I also don't know where the old one is anymore to find a part number for the one that will actually turn in the space allowed.
Anyone have the Ford part number handy for the original, and maybe who carries it, even if it's only available from a Ford dealer? My FLAPS do not, yet. I already replaced the points with Pertronix, and do not want to buy an MSD etc., so.......any help?
Thanks in "advance"!