ls5czu
New member
- Joined
- Nov 9, 2014
- Messages
- 3
- Reaction score
- 0
- Location
- Switzerland
- My Car
- Mustang 1973 Convertible 351C 2V
Corvette 1970 Coupe 454
Charger 1974 Rallye 400 4V
Hey, I'm on the way to fresh up my 1973 Convertible Survivor with only 16k miles, which I just bought. All still looks original , each and every bolt.
Now my question: The front crossmember looks somehow a little bit bent back on the driver side (in the area where the strut is attached). There is no hit visible in the front and especially not on the front of the crossmember (absolutely nothing). Now I have seen on some pictures in the internet with a similar asymmetrical bent...but the pictures where not so good quality. Could it be that it is from factory somehow asymmetric with a bent on the driver side? Hope you can give me some feedback from your experience...or even a picture of yours. Thanks Markus
Now my question: The front crossmember looks somehow a little bit bent back on the driver side (in the area where the strut is attached). There is no hit visible in the front and especially not on the front of the crossmember (absolutely nothing). Now I have seen on some pictures in the internet with a similar asymmetrical bent...but the pictures where not so good quality. Could it be that it is from factory somehow asymmetric with a bent on the driver side? Hope you can give me some feedback from your experience...or even a picture of yours. Thanks Markus