- Joined
- Nov 14, 2020
- Messages
- 220
- Reaction score
- 261
- Location
- West Chester, Oh
- My Car
- 1972 "Q" code Mach 1
Greetings,
About nine years ago I found this 1972 Mach 1 Mustang in Stowe, Oh. The VIN# says it’s a “Q” code car.
The car is equipped with some aftermarket goodies including Performer Intake, 750 Holley, Headers, aftermarket mufflers, a Mallory Uni-Lite Distributor, and plug wires. The engine in it is not original as it has 2V cylinder heads. Internally it has a Sig Erson hydraulic cam with stud mounted Crane aluminum rockers. Someone installed a Hurst V-Matic Shifter for the C-6 and had a boot made to resemble a 4- speed set up with a “T’ handle.
Since I race my 1988 Hatchback Mustang in NHRA Stock Eliminator I haven’t done a whole lot with the car. I cleaned up the under-hood wiring, replaced the Edelbrock Carb with the Holley, and worked to get the paint (more on that in another post) shined up and sealed. Now that I am retired, I have been paying a bit more attention to it. Lots of little issues to address. Have had it out to a couple outdoor car shows including the October 2019 “Pumpkin Run” in Owensville, OH. Overall, the car presents a nice appearance when driven which garners some ego satisfying thumbs-up from other motorists.
Hope to glean some knowledge from fellow members and check out their machines.
Attached are some pics of my Mach 1 and the ’88 Stocker that inhibits me working on it more. LOL
About nine years ago I found this 1972 Mach 1 Mustang in Stowe, Oh. The VIN# says it’s a “Q” code car.
The car is equipped with some aftermarket goodies including Performer Intake, 750 Holley, Headers, aftermarket mufflers, a Mallory Uni-Lite Distributor, and plug wires. The engine in it is not original as it has 2V cylinder heads. Internally it has a Sig Erson hydraulic cam with stud mounted Crane aluminum rockers. Someone installed a Hurst V-Matic Shifter for the C-6 and had a boot made to resemble a 4- speed set up with a “T’ handle.
Since I race my 1988 Hatchback Mustang in NHRA Stock Eliminator I haven’t done a whole lot with the car. I cleaned up the under-hood wiring, replaced the Edelbrock Carb with the Holley, and worked to get the paint (more on that in another post) shined up and sealed. Now that I am retired, I have been paying a bit more attention to it. Lots of little issues to address. Have had it out to a couple outdoor car shows including the October 2019 “Pumpkin Run” in Owensville, OH. Overall, the car presents a nice appearance when driven which garners some ego satisfying thumbs-up from other motorists.
Hope to glean some knowledge from fellow members and check out their machines.
Attached are some pics of my Mach 1 and the ’88 Stocker that inhibits me working on it more. LOL
