- Joined
- Feb 29, 2012
- Messages
- 1,582
- Reaction score
- 8
- Location
- SoCal
- My Car
- 73 Mustang Convertible
Born an I-6, spent the teenage, 20 and 30 years as a 302, but at 40 will reach full potential as a 351C.
I'm thinking tape off the opening...Fine wire wheel on a drill to start then finish with a Dremel and a fine wire wheelHere is a photo of the water neck area of my engine block where the thermostat goes.
Any ideas on how best to clean up this area?
+1 then vacuum/magnet/wipe the debris out.I'm thinking tape off the opening...Fine wire wheel on a drill to start then finish with a Dremel and a fine wire wheelHere is a photo of the water neck area of my engine block where the thermostat goes.
Any ideas on how best to clean up this area?
Enter your email address to join: