164runner
Well-known member
73 mach 1 351c 2v, c-6 auto. this is the second set of headers. first set was dougs and they hit the clam shell motor mounts on both sides. I have since changed the motor mounts and frame brackets to the 71-72 ones. just installed the hooker headers, pass side is so close to the trans pan that it can not be removed and collector is too close to trans causing excess heat to the trans. only thing I know to do is 1 heat the tubes and pull the collector over, 2 cut the collector off at a small angle turn it 180 and reweld it back on, 3 send headers back and put manifolds back on. if car had c-4, fmx, or 4 speed it would not be a problem. any one have suggestions ?
:chin:
:chin: