floorpan support

[Travi16]

SHould the floor pan support be weld to the floor pan. On my car someone has replaced the floor pan in the past and under the car there is a gap between the floor pan and floor pan support.I'm not sure what else could be going on.

 

[mdunlap]

SHould the floor pan support be weld to the floor pan. On my car someone has replaced the floor pan in the past and under the car there is a gap between the floor pan and floor pan support.I'm not sure what else could be going on.

Check out page 3 of "Grabber Green 71 mach 1 restomod."

It looks like they are spot welded.

 

[tempestairbrush]

There should be spot welds form support to the floor pan flush and yes your probably right it sounds like someone that replaced the floor pan probably cut it a little too short and didn't match the arch perfectly leaving the gap in between the pan and the support.

SHould the floor pan support be weld to the floor pan. On my car someone has replaced the floor pan in the past and under the car there is a gap between the floor pan and floor pan support.I'm not sure what else could be going on.

 

[1972MustangSVH]

"Check out page 3 of "Grabber Green 71 mach 1 restomod."


It looks like they are spot welded.

You know your amassing information when the answers come in this form.

 

[stevehcode]

As mdunlap said check out my grabber green mach build thread. They are spot welded every inch and a half or so along the frame rails and across the front half where it meets the firewall.