- Joined
- Apr 22, 2013
- Messages
- 1,023
- Reaction score
- 8
- Location
- san diego
- My Car
- 1973 mustang convertible(some day)
I'm hooking up my 4R70W controller and it requires I hook up power to "ignition switch power wire"
see pic2
pic3 is from schematics for ignition switch. If I had to guess I think it would be the "start" R-LP (red-light blue)
Pic1 is a pic of my current wiring. You can see someone spiced the R-LB wire for alarm before. There was lots of stuff taken off the red and MAYBE yellow wire.
I also need to bypass my tech to get it to work with my Pertronix as shown in attached thread
http://www.7173mustangs.com/attachment.php?aid=11538
Note that this calls for a "red and yellow wire" for ignition wire which I don't see in the schematics.
My question is does anyone know where I should tie into?
The red and light blue or red and yellow (?? not sure as this is faded as seen in pic1)
Thanks for any input!
Jim
see pic2
pic3 is from schematics for ignition switch. If I had to guess I think it would be the "start" R-LP (red-light blue)
Pic1 is a pic of my current wiring. You can see someone spiced the R-LB wire for alarm before. There was lots of stuff taken off the red and MAYBE yellow wire.
I also need to bypass my tech to get it to work with my Pertronix as shown in attached thread
http://www.7173mustangs.com/attachment.php?aid=11538
Note that this calls for a "red and yellow wire" for ignition wire which I don't see in the schematics.
My question is does anyone know where I should tie into?
The red and light blue or red and yellow (?? not sure as this is faded as seen in pic1)
Thanks for any input!
Jim