B
BigPinoyHunk
Guest
Alright guys i have about 1000ish miles on my 466 that i want to sell off completely minus accessories brackets. here is a short run down of the motor:
71 block
c9ve heads (the good ones) ( roofs raised and humps removed )
cobra jet rods with arp rods bolts
forged pistons with -24cc dish
9.4-9.5 CR (i mainly ran 89 octane)
crane 1.7 rocker arms
weiand stealth
Comp cam xe274 cam
custom cal'd carb to motor 800cfm DP (de horned and etc and flows 850)
stock oem oil pan
stock valve covers
std volume oil pump
I ran a best of 12.69 with this motor and trapped at 108MPH. when i've been talking to builders, with the weight of the 73, the trans, the gears, and the MPH ET, they are estimating north of 450-475HP.
i am in the WANT of a 521+ stroker so this motor must go. if you are local, i can wait until you see the motor run and verify it runs good and has good vacuum and yada ydad yada or whatever. i am hoping not to have to have the motor sit for a period of time once the motor gets pulled and the new motor is running. the new motor will be over 600+ hp and ideally i run a low 11 second 1/4 ET.
i'm thinking with a completely complete motor minus accessories brackets looks good at $2500 or OBO. i'm also wanting to sell off the automatic engine plate, and flexplate with the motor.
if you really want, i will throw in the c6 thats been sitting out in the rain for FREE. it was mated with the motor originally before the tko600.
i am located near SACRAMENTO CA!!!
71 block
c9ve heads (the good ones) ( roofs raised and humps removed )
cobra jet rods with arp rods bolts
forged pistons with -24cc dish
9.4-9.5 CR (i mainly ran 89 octane)
crane 1.7 rocker arms
weiand stealth
Comp cam xe274 cam
custom cal'd carb to motor 800cfm DP (de horned and etc and flows 850)
stock oem oil pan
stock valve covers
std volume oil pump
I ran a best of 12.69 with this motor and trapped at 108MPH. when i've been talking to builders, with the weight of the 73, the trans, the gears, and the MPH ET, they are estimating north of 450-475HP.
i am in the WANT of a 521+ stroker so this motor must go. if you are local, i can wait until you see the motor run and verify it runs good and has good vacuum and yada ydad yada or whatever. i am hoping not to have to have the motor sit for a period of time once the motor gets pulled and the new motor is running. the new motor will be over 600+ hp and ideally i run a low 11 second 1/4 ET.
i'm thinking with a completely complete motor minus accessories brackets looks good at $2500 or OBO. i'm also wanting to sell off the automatic engine plate, and flexplate with the motor.
if you really want, i will throw in the c6 thats been sitting out in the rain for FREE. it was mated with the motor originally before the tko600.
i am located near SACRAMENTO CA!!!
Last edited: