87fox72mach
Well-known member
- Joined
- Apr 22, 2011
- Messages
- 927
- Reaction score
- 21
- Location
- pa
- My Car
- 1995 firebird rebuilt motor 5 spd dail driver
1987 grand wagoneer plow truck
1987 mustang lx 5.0 work custom engine bay and paint
1972 mach 1 project
I have a few questions regarding clutch linkage installation. My car was in pieces when j got it. I have never seen linkage fully assembled in person so I'm a little confused.
1. Is there a felt washer on both the frame rail side ball mount. And the trans side ball mount. I already replaced the plastic bushing that's ball shaped on the bell housing side and there is some sort of rubber seal there as well
2. In the pic below my 90 degree elbow thing that 5he rod goes through to clutch fork is very wobbly and loose. But looks like it's a rivet. How can I fix this? Where can I get one? What's it even called?
I seen diagrams but am looking for clear answers. Thanks
1. Is there a felt washer on both the frame rail side ball mount. And the trans side ball mount. I already replaced the plastic bushing that's ball shaped on the bell housing side and there is some sort of rubber seal there as well
2. In the pic below my 90 degree elbow thing that 5he rod goes through to clutch fork is very wobbly and loose. But looks like it's a rivet. How can I fix this? Where can I get one? What's it even called?
I seen diagrams but am looking for clear answers. Thanks