Partial rear C-pillar skin, fastback, RH

[cudak888]

Title says all - I need the rear half of a right-hand C-pillar/quarter panel skin. Enough to replace the damaged bit here - preferably a bit of the portion past the quarter edge too, so I can line it up with a repop panel:

-Kurt

 

[Qcode351mach]

Title says all - I need the rear half of a right-hand C-pillar/quarter panel skin. Enough to replace the damaged bit here - preferably a bit of the portion past the quarter edge too, so I can line it up with a repop panel:

-Kurt

K..why don't you try to straighten..Hammer dolly & shrinking disk...You have nothing to lose but some time...You might surprise yourself

http://allshops.org/cgi-bin/community/communityalbums.cgi?action=openalbum&albumid=9980121727059

There's lots of vids on you tube on how to repair sheet metal

 

[cudak888]

K..why don't you try to straighten..Hammer dolly & shrinking disk...You have nothing to lose but some time...You might surprise yourself

http://allshops.org/cgi-bin/community/communityalbums.cgi?action=openalbum&albumid=9980121727059

There's lots of vids on you tube on how to repair sheet metal

Hammer and dolly, possibly - but I'll probably wind up losing money in tools before doing a good job.

I do plan on using a shrinking disk on one spot behind the quarter window though, but there are low spots on the rear half of the quarter that I cannot get to with a shrinking disk.

My mind is made up here - a donor panel is going in at this spot, if nothing else.

-Kurt

 

[mweeps]

I bought a set from Eastwood for $80 bucks. You can buy Cheaper ones or more expensive ones.

 

[OMS]

I'm thinking I have 3 to choose from - I'll take a look

 

[droptop73]

Either way you do that job it will be challenging.

 

[cudak888]

I'm thinking I have 3 to choose from - I'll take a look

Thanks, Don.

FYI, one of the other forum members mentioned he has one, but I'm open to everything available.

-Kurt

 

[OMS]

good you got it covered then

 

[cudak888]

good you got it covered then

10-4. I'll send you a PM if I decide against the one I have a lead on.

-Kurt

 

[OMS]

good you got it covered then