jmcgill89
Well-known member
I've been looking at the wiring diagram and trying to translate everything to the connector for my printed circuit.
When I take a Volt/Ohm meter to the connector with the key in the "on" position, I get power from a couple of the wires, but not all of them. For instance, when I turn the lights on, I get power to the light blue/red wire. I also seem to get power to the thick red and black wires there...but nothing else.
I'm trying to decide whether my printed circuit is shot or whether I have some sort of wiring issue.
When I take a Volt/Ohm meter to the connector with the key in the "on" position, I get power from a couple of the wires, but not all of them. For instance, when I turn the lights on, I get power to the light blue/red wire. I also seem to get power to the thick red and black wires there...but nothing else.
I'm trying to decide whether my printed circuit is shot or whether I have some sort of wiring issue.