Accidentally cut the metal fuel line

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Do you have a link to an example of that compression fitting ?
Here's the setup I use for my fuel inlet into my carb. Its a hard metal preformed line, and the compression fitting that fits that line and gives something like a 6an thread so you can screw on different things. I use a little hand held pipe cutter to cut the steel line. But it sounds like you've already taken care of that. :D

And pro-tip, the copper ring is single use. If you tighten the thing in the wrong spot, the copper ring is stuck there and you have to cut it off. I was able to find a little pack of the copper rings at the local oreileys auto store for a couple bucks. You can use those with the rest of the fitting to try again.

1729603441863.png

1729603419488.png




https://www.summitracing.com/parts/VPE-16445
https://www.summitracing.com/parts/SDK-MGL024
https://www.summitracing.com/parts/EDL-8131

Here's the counterpart to my 5/16 one. If all you did was cut a line, I supposed you could use the 2 of these to get it back together. https://www.summitracing.com/parts/vpe-16455
 
Last edited:
Here's the setup I use for my fuel inlet into my carb. Its a hard metal preformed line, and the compression fitting that fits that line and gives something like a 6an thread so you can screw on different things. I use a little hand held pipe cutter to cut the steel line. But it sounds like you've already taken care of that. :D

And pro-tip, the copper ring is single use. If you tighten the thing in the wrong spot, the copper ring is stuck there and you have to cut it off. I was able to find a little pack of the copper rings at the local oreileys auto store for a couple bucks. You can use those with the rest of the fitting to try again.

View attachment 94500

View attachment 94499




https://www.summitracing.com/parts/VPE-16445
https://www.summitracing.com/parts/SDK-MGL024
https://www.summitracing.com/parts/EDL-8131

Here's the counterpart to my 5/16 one. If all you did was cut a line, I supposed you could use the 2 of these to get it back together. https://www.summitracing.com/parts/vpe-16455
Awesome info. Thanks
 
I got the new Fuel line from NPD installed, and almost at the very end where it connects to the tank, I'm seeing this small kink.

Let me know if y'all think this will fly, or if I should check with NPD.

Screenshot 2024-10-31 at 5.37.15 PM.png
Screenshot 2024-10-31 at 5.38.20 PM.png
 
That kink will not hamper your performance; hook things up and run it !!!
I mean... ford made the fuel line that size for a reason. :D If the car would always work fine with less flow, they would have saved a few bucks on every car by running a smaller fuel line.

I think day to day driving, a slightly kinked line won't matter. It may be a different story when you want to run the motor wide open.
 
Back
Top