Three Ponies
Active member
- Joined
- Sep 5, 2016
- Messages
- 29
- Reaction score
- 3
- Location
- West Grove, PA
- My Car
- 1973 Convertible Restomod (5.0 HO motor, 24LB injectors, 75MM throttle body, E cam, Tremec TKO 5 speed, 4WDB and other fun stuff)
2000 GT Convertible (Roush conversion)
2004 Thoroughbred (the kind that poops)
1962 Thunderbird
1954 Mercury Monterey Sun Valley
I can't seem to get this "sag" out of my top frame over the driver side front. I've tried adjusting the frame "east/west" by loosening the mounts at the rear quarter and have good alignment on both windshield posts. I've messed with the hook and pin on the driver pillar to no avail. I loosened the two nuts on top of this portion of the frame and then discovered in order for the frame to move fore and aft, you have to remove the large phillips head screw on the side, but... that hole is countersunk for the screw, so that does not appear to help. I've even removed the screw, loosened the bolts and moved the front section forward (photo below) but it doesn't seem to help much. The top operates very smoothly, however, I can't seem to figure out this last adjustment. Does anyone else's top have this? Suggestions? I want to get this right before the fabric goes on (obviously).
Any ideas?
Any ideas?