power steering pump pully

[delawarebill]

drove down to ocean city md last sunday, about wednesday i heard a squealing and saw my fluid was low. had fluid on belly of unit. ck'd both lines and looked fine. so i'll assume it's the input shaft seal.. i've heard they are a bear to remove, never had a need to do one.. so be better just to buy a rebuilt one or do a rebuild on it? and suggestions on pulling the pulley off too. it's the round type with small cooler on top.

 

[73pony]

I have one I purchased as a reman with the resivoir. Still has factory pulley on it. You would need to put your cooler on it. Only has maybe 50 miles on it. You can have for just cost of shipping if you want. It is off a 351c.

 

[73pony]

Here is a couple pics of the pump.

 

[delawarebill]

does it need to be cleaned out.. looks like it's be blasted..

 

[73pony]

Should not need to be cleaned. This is just how I received it. It was painted with silver paint. I just didn't bother to repaint it the correct color.

 

[delawarebill]

jason, sounds good... u have a pm